However, the last thing I did, and that was what worked, was to extract 2 files from the tar file and place them like this: I solved this problem and it was not too hard I am not a linux expert but I will post the steps I followed. SET failed on device eth2 ; Operation not supported. Copy the contents of ifcfg-wlan0 to the ifcfg-wmaster0. Wed Nov 09, 7:


Uploader: Fenriramar
Date Added: 8 January 2005
File Size: 32.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 95080
Price: Free* [*Free Regsitration Required]


I describe it as a second stutter, with keyboard entry and mouse movements only in about a one second gap between these ‘stutters. You are not directly subscribed to this bug’s notifications. With the command line, I get this message: However, I don’t have the hardware it’s arriving early next week so I can’t test it.

rt [Aircrack-ng]

JP See, there are kernel modules for each and every part of the hardware, which helps the operating system to communicate with the hardware. Hosting by Gossamer Threads Inc. This article describes how to setup an wireless network under Slackware Comment on this change optional.


Beforehand thank you very much. The module is called rtpci. If its not there then reload the rt Mon Nov 07, 3: If they are disabled menuconfig does not offer the Ralink menues.

Apologies I’m not familiar with any commands that could be used to debug ft2500-cvs-daily.tar.gz card problems.

I installed the following repo. I think I explained the concept pretty clearly. May the Force be with you: I loved the the writing however. Fri Nov 04, 8: So, you have to remove or unload that module we insert or load modules which are required for communication.


Join Date Jun Posts 5. Whenever I try to activate the device, I get the following error:. RT compile problem hhmm Sometimes it comes back on its own, other times I have to deactivate and reactivate the card on the network configuration or by console.

Setting up a Wireless Network with Slackware 12

Email me about changes to this bug report. No existe el fichero o el directorio. Mon Nov 07, 1: Thanks rt2500-cvs-daily.tae.gz this immediate support! Oh, and I also notice that the Internet can stop working for some minutes.



RaLink rt2500-cfs-daily.tar.gz wireless card not seeing networks in edgy Bug reported rt22500-cvs-daily.tar.gz seanh on I will try to post a new ebuild in the next few days if nobody beats me before. View unanswered posts View posts from last 24 hours. Tue Nov 08, 7: Untar the download driver tar ball and change to the directory. It does now, the ebuild itself should be good to go, the driver on the other hand I can also confirm that if I enter the ESSID manually I can connect, and that if I run ‘sudo dhclient ra0’ rt2500-cvs-saily.tar.gz a terminal it can find dhcp networks and connect to them fine.

The solution as described in many post over the internet is to compile the RT drivers from source.